Xtyoux เครื่องไล่หนูอิเล็กทรอนิกส์สําหรับในรถยนต์

Working principle:
At present all kinds of cars are frequently attacked by rats. Rats often penetrate into the engine compartment of a car bite off wiring or oil pipes and other components. it can cause the car to fail to start.or even cause the car to spontaneously ignite if seriously causing unexpected disasters. In order to prevent rat from harming automobiles we have accumulated nearly 20 yearsexperience in technology and market and dedicated electronic rodent repellent for automobiles.
The product can intermittently and alternately emit two different frequencies and waveforms of ultrasound which can effectively eliminate mice entering the car.
This product uses the most modern microelectronic technology means can alternately and intermittently emit two different special waveforms and frequencies of ultrasound acting on the rats auditory system and nervous system making it uncomfortable and unpleasant and escape from the scene. Because the frequencies of these waves change intermittently they do not produce adaptability and immunity in mice.
This product uses special automatic control circuit when the car stops parking the product will start to work; when the car starts vibration will occur the product will stop working.
Scope of application:
This product is mainly used in engine compartment of various automobiles to prevent mice from entering engine compartment to damage automobiles.
This product is mainly used to expel mice. At the same time it can also inhibit cockroaches ants spiders crickets bedbugs fleas silkworm moths and so on.

Specifications:
Power supply: DC12V
Working current: 5-40 mA
Product power consumption: 0.48W
Operation mode:
Start-up self-check: When the initial power supply is turned on the product is self-check. First the red light flash three times then the white light flash three times and then the alarm sounds.
Workflow:
For 1-15s the red light flashing three times and then outputs 12K-25kHz ultrasound while the white LED light flashing. 16-30 seconds product standby. 31-50s repeat 1-15s 51s-1min 10s product standby. 1 minute 11 seconds - 1 minute 40 seconds repeat the process for 1 - 15 seconds.
After completing the above actions stop for 1 minute then repeat the above actions twice stop for 3 minutes and 5 minutes respectively.
Red light always corresponds to slow sweep mode green light always corresponds to fast sweep mode.
There are three modes of white light flashing: fast medium and slow flashing each mode flashing 10 times repeating work.

Vibration induction:
When the power supply voltage is higher than 9.2V the product goes into working state. When the product detects the vibration of the car it stops working automatically. After parking for 5 minutes the product starts automatically and resumes work.
Low voltage alarm:
When the power supply voltage is below 9.2V the product enters the alarm mode and emits an alarm sound of 1hz which will continue. In this case the product does not work.

Notes:
1. Do not place the product in a damp leak.
2. It is strictly forbidden for any liquid to enter the interior of the product.
3. The power cord of the product should be as far away as possible from the heating parts inside the engine room.


Included:

1 XRodent Repellent